This
level-5 vital article is rated C-class on Wikipedia's
content assessment scale. It is of interest to the following WikiProjects: | ||||||||||||||||||||||||||||||||||||||
|
While an electric heating element is 100% efficient at converting electrical energy into heat, not all of this heat gets into the required water. A significant proportion is used to heat the kettle itself. Also, the minimum volume mark might be at a much larger volume than required. A 1.5 l plastic jug kettle with an exposed element might have a heat capacity equivalent to an additional 105 ml of water. A stainless steel squat kettle (non-jug) with a concealed element might have a heat capacity equivalent to an additional 230 ml of water.
The effective heat capacity of a kettle can be determined experimentally by boiling the minimum and the maximum volumes of water in the kettle from cold. Plot the 2 times against the volumes and draw a line between them, extending it until it crosses the volume axis. This should be a negative volume. The absolute value of that volume is equivalent to the effective heat capacity. Where the line crosses the time axis, this should be a positive value and indicates how much longer you have to wait just to heat up the kettle. You can check your experimental technique by repeating the measurements or by boiling another known volume of water somewhere between minimum and maximum. The resulting (volume,time) co-ordinates should lie on the same straight line.
An 'efficiency' value for a kettle can be defined as the ratio of the energy required to heat a desired volume of water (e.g. 220 ml standard cup) to the energy required to boil the kettle.
For the plastic kettle, the minimum volume mark corresponded to 350 ml. Add to this the additional volume for the heat capacity (105 ml) and the efficiency for a 220 ml cup full can be calculated as 220 / (350 + 105) or 48%.
For the metal kettle, the minimum volume mark corresponded to 550 ml. For a 220 ml cup, its efficiency is 220 / (550 + 230) or 28%.
(The above figures were derived from actual kettles. I ignored heat losses from the kettle, which might be 5-10%, as they are insignificant compared to the heat capacity of the kettle and extra water. The heat loss from a plastic kettle will be less than from a metal kettle as the outside surface temperatures are much lower for plastic. Also, kettles are often filled well above the minimum mark. Both of these factors will combine to reduce the above efficiency values still further. I have also ignored simple methods of reducing energy consumption; such as immediately refilling the kettle to the minimum mark after use so that the kettle starts warmer next time.)
There are several reasons the metal kettle has the higher heat capacity:
Ajrobb ( talk) 04:19, 11 October 2008 (UTC)
Should there be something in this article giving the principles of the kettle? Obviously one of those principles is that it allows water to be exposed to a source of heat. However shouldn't there also be something along the lines of "Thermodynamically isolate the system to stop convection and conduction from equalizing the inside temperature with the outside temperature?" After all the article on Solar greenhouse gives exactly that as the first principle of the greenhouse. Or do you feel that it is the greenhouse article that inappropriately overemphasizes the significance of this isolation principle? -- Vaughan Pratt ( talk) 04:53, 7 November 2009 (UTC)
According to this article, http://www.wickedlocal.com/carver/archive/x1713644944/Carver-home-of-the-teakettle Carver, Massachusetts claims to have produced the first tea kettle.
Rogerwho? ( talk) 20:28, 10 December 2008 (UTC)
What are the factors involved in time taken by electric kettles to boil a cup of water? I'm always amazed in the variation in time taken by different kettles. Unfortunately, my current model is the slowest I've ever seen :-( -- 83.38.126.5 ( talk) 14:38, 11 May 2010 (UTC)
An editor posted me a link to a 1800 advertisement for the Lloyd's Patent Table Kettle and suggested it might be added to the article Kettle. I am not sure exactly how this could be done or what a table kettle looks like (maybe like this?). Here is the text:
SINGLE LADIES or GENTLEMEN living in Apartments, at Breakfaſt or Tea-time, after Supper, at any time of the day or night, from one quart to one gallon of Boiling Water may be had on the Table every Ten Minutes, for leſs than One Penny expence, by means of LLOYD'S PATENT TABLE KETTLE, which, for Sick Rooms, is declared to be truly invaluable. - To be had only of the Inventor and Patentee, No 178, Strand, two doors Weſt of Norfolk-∫treet , where it may be ∫een in actual uſe.
— The Times, 29 May 1800
- 84user ( talk) 11:02, 12 May 2011 (UTC)
> "A kettle, sometimes called tea kettle, teakettle or tea pot" I don't think this is correct - does anyone call a kettle a "tea pot"? Tea pots are for putting tea in, surely, not for heating the water. Dictionaries seem to agree with me so I've corrected this unless someone can cite a reliable reference. Gymnophoria ( talk) 20:43, 23 June 2011 (UTC)
Used "...in preparation for making tea or other beverages requiring hot water. Kettles often resemble teapots, but are used to boil water, not to brew tea."
Most kettles do not look like teapots. Kettles can be used to heat water for any purpose, not just making tea. 92.29.120.26 ( talk) 21:31, 28 June 2011 (UTC)
The automatic switch off mechanism after boiling of most modern kettles, along with any secondary boil dry mechanism also, are not even mentioned let alone decribed and explained in this or related articles.
I first I thought that the primary mechanism was a bimetallic switch it is clear however that the vertical post with a hole in it is likely an capilliary to an air pressure sensor switch that gets triggered either by the -ve vacuum produced by the escaping steam or +ve pressure of same into the tube. Any self-resetting bimetalic switch is liekly to be used inline and attached immediately adjacent to the element for overheat or boil dry protection.
So there is much more to humble electric kettle tech than meets the eye! 122.148.41.172 ( talk) 06:11, 11 July 2012 (UTC)
For whomever most cares for this page, please know that the Svenska language link links to the wrong English article. This English "kettle" article links to a Svenska "kittel" article. Though the words are obviously etymologically related, Swedish "kittle" means "cauldron", NOT "kettle". To the best of my ability, I believe the Swedish word for kettle is "vattenkokare". However, the Swedish wiki entry for "vattenkokare" focuses only on / and links to "electric water boilers". Though one could exist, I haven't found a kettle article in Swedish. I'll post on the Swedish sites as well, since things perhaps need to be untangled on that end. :) Pillartopost ( talk) 14:57, 1 August 2012 (UTC)
It's easier, and much safer to pour boiling water from a kettle, than a saucepan. 86.171.198.162 ( talk) 03:03, 4 October 2013 (UTC)
Well he finally did get a cuppa!
220 of Borg 12:53, 12 October 2016 (UTC)
Hello fellow Wikipedians,
I have just modified one external link on Kettle. Please take a moment to review my edit. If you have any questions, or need the bot to ignore the links, or the page altogether, please visit this simple FaQ for additional information. I made the following changes:
When you have finished reviewing my changes, you may follow the instructions on the template below to fix any issues with the URLs.
This message was posted before February 2018.
After February 2018, "External links modified" talk page sections are no longer generated or monitored by InternetArchiveBot. No special action is required regarding these talk page notices, other than
regular verification using the archive tool instructions below. Editors
have permission to delete these "External links modified" talk page sections if they want to de-clutter talk pages, but see the
RfC before doing mass systematic removals. This message is updated dynamically through the template {{
source check}}
(last update: 5 June 2024).
Cheers.— InternetArchiveBot ( Report bug) 21:15, 4 May 2017 (UTC)
Hi User:Andy Dingley. Why did you revert this please? I added relevant referenced content to the article earlier. Zigzig20s ( talk) 23:37, 12 May 2018 (UTC)
I was reading that Sholom Borgelman owned a sheet metal company and invented the tea kettle after WWI. Enigma msg 19:19, 12 November 2018 (UTC)
First, the references cited do not seem to be very serious. To say at least.
Second. Since I moved to the US I also noticed they don't use electric kettles as often as Europeans, but this cannot be related to the voltage. Although it's true that an usual American electric outlet cannot give as much power (around 1.5 kW) than an European one (up to around 3 kW), most of the kettles I encountered in Poland and Iceland were around 2 kW, which is not significantly more than the one I have in the US now, which is 1.5 kW. It also wasn't difficult to buy it. Since 1.5 kW of power is enough to boil a liter of water in reasonable and insignificant time, the reason for a lower electric kettle "market share" in America must be different. Maybe it's something like a custom or cultural difference. But not mains power. Borys1703 ( talk) 07:13, 1 October 2019 (UTC)
There is, I believe, an excessive amount of images especially when one considers the inclusion of the Gallery section. What might be the thoughts of others? Hu Nhu ( talk) 17:30, 29 February 2020 (UTC)
Significant portions of the article are written as if preparing tea is the primary or sole purpose of a kettle. In particular:
I would guess the term "tea kettle" originated from a time when "kettle" had a broader meaning. Maybe in some cultures kettles are primarily associated with tea. In others, they may be primarily associated with coffee or some other beverage. Here in Britain, kettles are probably associated with tea and coffee pretty much equally. Of course, there are many other uses. Maybe in yet other cultures, the primary use would be to boil water in order to cook vegetables, rice, etc.
I'm going to try and improve the article a bit, but can anyone help? — Smjg ( talk) 18:09, 12 December 2020 (UTC)
An editor has identified a potential problem with the redirect Spying kettle and has thus listed it for discussion. This discussion will occur at Wikipedia:Redirects for discussion/Log/2022 October 7#Spying kettle until a consensus is reached, and readers of this page are welcome to contribute to the discussion. Tartar Torte 19:13, 7 October 2022 (UTC)
The tone hole is a pitch-altering implement, a hole that can be opened or closed to change the pitch. The kettle sounder has nothing like that, it is simply a whistle. Викидим ( talk) 08:33, 25 December 2022 (UTC)